Capacity Tester Cell Charge Discharge Tester 5v,3A/6A/10A/20A/30A/50A/60A/100A/200A

Introduction

The device is mainly used for the primary charging of super capacitor. The whole machine is composed of a formation unit and a set of pressing machine, in which the formation unit has 16 channels and 1 layer, each layer has a set of press corresponding to it, and each formation unit is composed of 16 channels of 5V 100A. The circuit connection between the battery and the equipment is realized by the probe. The probe is installed on the pressing machine, and the whole tray capacitance is put into the equipment manually. The needle bed mechanism of the device presses the probe and the positive and negative poles of the capacitance through appropriate pressure, so as to realize the fast and reliable connection between the needle bed and the capacitance.2.1 Requirements and objectives of scheme designAt present, customers need to test the capacity of cylindrical capacitor, and the applicable battery specifications (as shown in the table below): the detailed dimensions shall be subject to the battery outline dimension drawing.

3.1) Connect the power supply of equipment and debugging device;2) Put the debugging tray into the needle bed;3) Connect the cable and communication line of debugging device (including computer, multimeter and debugging tray);4) Start the special software of the computer calibration tooling system, set the parameters and start the test. After start-up, the computer will automatically control the power supply equipment to enter the charging / discharging state according to the set current value. At the same time, it will control the test device to switch channels, calibrate or measure the set channels. After the test is completed, the data will be automatically summarized into excel table.

1. Energy saving, Eco-friendly.2. modularization design, smaller size, less weight, convenient to install and maintain.3. higher power rating , lower heating, fast and stable running.4.Two poles structure designs, shorter circuits, higher power efficiency.5.Border upon any connects, higher use ratio.6.Current loop and constant voltage loop are both running together on the hardware, control over current and over voltage verywell, enable the safety protection to work all time during battery testing7.Accuracy range according to the module, enhance the accuracy of huge current equipment.8.hardware output only, fast response, high running speed ,smaller ripple wave9.Each channel individual control, double DA loop circuit, individual constant current source and constant voltage source.10.Multiple protections with both hardware and software included and so equipment running gets much safer.11.Support the simulation of battery work condition12.Using Linux software and the system goes quite safe and stable.13.Support offline running which keeps the data quite safe.