13.56 Mhz Rfid Card Reader Module with USB Interface Built in Antenna

The IC card reader canset five output format steps:

1. UseIC card to set output format, such as IC card number (called A card): B5 BB 23FE (opposite to the UID read by NFC mobile phone software, we call it reverseorder, and vice versa.)

2. TheIC card is not detected within 1 second after power-on, and the setting fails.The card reader output is the card number in the current format.

3. Ifthe IC card is detected within 1 second of power-on, it will enter the setting state(it is better to put the A card in the card reading range of the card readerfor power-on). At this time, the LED light will flash continuously (about 5seconds). Please start setting within this period.

1)Swipe another IC card (called card B) once, and then swipe card A again or waitfor 5 seconds. The card reader is successfully set, and the output IC cardnumber is the 10-digit decimal reverse sequence: 3048940542 (8H10D, take 4bytes to 10 digits)

2)Brush the B card twice in succession, and set the output card number to 8-digitdecimal reverse order: 12264446 (6H8D, the last 3 bytes are converted to 8bits)

3)Brush the B card three consecutive times, and set the output card number to8-digit decimal reverse order: 18709214 (2H3D4H5D, the second byte turns to 3bits, and the second byte turns to 5 bits)

4)Brush B card 4 times continuously, and set the output card number to hexadecimalreverse order (8H or 14H): B5 BB 23 FE

5)Brush B card 5 times continuously, and set the output card number tohexadecimal positive sequence (8H or 14H): FE 23 BB B5

4. Inthe configuration mode, swipe the third IC card (called C card), and the cardreader is set to not carry the carriage return.

5. Inthe configuration mode, swipe the A card again to confirm to exit theconfiguration.

Features：

l          The farawaydistance

l          Various voltage optional

l           Read CSN card number only

l           With burgersand LED lights

              Differentoutput formats

  Application:

l                   Tablet PC

l                   Lift control

l                   POS terminal

l                   Parking system

l                   Access control

l                   Handheld terminal

l                   Attendance application

l                   Recreational Machine

l                    Barrier gate/rapid-open gate

ModuleNO.:

Parameter: